About WireGuardLab
WireGuardLab covers WireGuard as a protocol and as a deployment: key handling, what AllowedIPs really controls, NAT traversal and keepalives, mesh topologies, MTU tuning, and the cryptographic design that makes the configuration so short.
It is for people who want to configure WireGuard deliberately rather than paste a template. Coverage follows the WireGuard protocol paper and the official documentation.
What is covered here
- Comparisons
- Deployment Guides
- Protocol Fundamentals
- Troubleshooting
6 articles are published so far. New articles are announced on the RSS feed; there is no fixed publishing schedule and this site does not promise one.
Tools
The mesh designer is the one interactive page here. It
takes a topology, a peer count, an overlay subnet and an underlying transport, and
returns a wg0.conf skeleton, the number of tunnels that topology implies,
and the MTU that transport implies. It runs entirely in the browser: nothing is sent
anywhere, no key is generated for you, and there is no signup. The arithmetic behind
the MTU figure is set out in
the MTU calculation article, so you can
check it rather than trust it.
How these articles are produced
Articles are researched from primary sources: vendor and project documentation, published standards and specifications, release notes, advisories, and measurements published by the people who took them. Drafts are produced with AI assistance and then edited against those same sources before anything is published. Where a figure comes from a datasheet or a third-party measurement, the article names the source and links to it so you can check the original rather than take this site's summary of it.
Everything here is published under the WireGuardLab Editorial byline. That is an editorial desk, not a person, and no article on this site claims hands-on lab testing, benchmarking, or first-hand measurement. Nothing here should be read as a report of something this site physically tested.
Corrections
Getting it right matters more than getting it first. If something on this site is wrong, out of date, or missing the source it should cite, email editor@wireguardlab.com with the page and the specific claim. Substantive corrections are made on the page itself rather than quietly dropped.
How this site is funded
This site currently runs no affiliate links, no sponsored content, no paid placement, and no display advertising. Nothing on it earns a commission. If that changes, this page and the disclosure page will say so before any such link appears.
The full position is on the disclosure page. Read it before acting on anything here that reads like a buying recommendation.
Related sites
WireGuardLab is run alongside a small number of other single-topic sites:
- Cloudflare Zero Trust Guide - Cloudflare Tunnels, Access Policies & WARP Client Device Posture
- OPNsenseLab - OPNsense guides, configs, and hardware for serious homelabs.
- pfSenseLab - pfSense and pfSense Plus configuration for homelabs.
- ProxmoxGuide - Virtualize with confidence.
Contact
Email: editor@wireguardlab.com
Site: wireguardlab.com
Privacy: privacy policy ·
terms of use